22,2mm phi handle car in esclusiva per 12 V
Lunghezza totale della presa : 120mm di tipo passante di fine corsa (Bar-end può essere installato)
Diametro interno dell'impugnatura (a destra) : 24,4mm phi (a sinistra) : Φ21.2mm
Impugnatura O.D. : Φ33.6mm
*LIVELLO3&4 non è adatto per l'uso con i livelli 3 e 4 in quanto può causare problemi di batteria e ustioni a bassa temperatura. Si prega di utilizzarlo per un riscaldamento rapido.
*Il grafico della temperatura mostra i risultati delle misurazioni interne. Si prega di fare riferimento a questi valori come riferimento.
*Se il manicotto dell'acceleratore è dotato di nervature non rotanti, è necessario raschiare il manicotto in modo che corrisponda al diametro interno dell'impugnatura. Anche se il manicotto dell'acceleratore non ha un fermo, è necessario raschiare via il manicotto in modo che corrisponda al diametro interno dell'impugnatura.
*Manicotto piatto non disponibile.
*Assicuratevi di utilizzare l'adesivo Hot Grip (venduto separatamente).
Φ22.2mm handlebar 12V models only
Grip Length: 120mm End-through type (Bar end can be attached)
Grip inner diameter (right): Φ24.4mm (left): Φ21.2mm
Grip O.D.: Φ33.6mm
*Please be aware that running at LEVEL 3 & 4 may result in battery failure or low temperature burns.Use for rapid heating.
*The temperature graphs are measured indoors.Please refer to these values for reference.
*If the throttle sleeve has any ribs, you will need to remove them.Even if the sleeve does not have a non-turning stopper, please cut down the sleeve according to the inner diameter of the grip.
*Not compatible with FLAT throttle sleeve.
*Make sure to use the special adhesive for Hot Grip (sold separately).
*High temperature.Never touch with bare hands.
*Doing so may result in low temperature burns and battery overload.
*There may be changes in product specifications due to the manufacturer's reasons.