- I machined a lot of the suspension to install it. It took a long time and was hard work,
but I was very satisfied after installing this.
Because the performance came out as I hoped.
The motorcycle...Leggi di più - Since the suspension is originally soft, we installed it without orifice and pre-road as it is.Cushioning has increased considerably when driving the OffRoad course.Even in the case of a series of sma...Leggi di più
- I changed the spring to a DRC spring to get rid of the OEM's soft, uncontrolled, sloppy legs, butIt's a bit easier to apply the load than before, but it's still floppy due to the lack of pressure side...Leggi di più
- Wearing a NINJA400 (2020, 2BL-EX400G), POSH Used in conjunction with Initial AdjusterType2When I put the PD Fork Valve on the NINJA2 Helmet 50SL, the thrust is reduced and the valve is not as strong a...Leggi di più
- It is used in Z400GPIt is used in conjunction with the external product Fork Spring, which is in the genus With Spring The free length can be secured without processing in combinationThe feeling of us...Leggi di più
- The oil viscosity is the same, but the oil surface is the same as the OEM standardIn the instruction manual of the English version, there are instructions to drill a hole in the piston rod Translation...Leggi di più
- The current PD Valve does not require processing of DamperROD and the installation itself is fine, but the initial operation within legal speed hanghang.So, I am witnessing by adding holes in the init...Leggi di più
- Select Lay Stick's product for highBut Valve's BODY is Material : It seems that Plastic is a little Large for my F Fork Spring diameter, and it was necessary to adjust and adjust the diameter ...Leggi di più
- The postage on this item is way over the top being way too expensive at over 70$.. I have bought a lot of parts from your store and I feel that you are getting out of hand with your postage.. ple...Leggi di più
- Although it is not an impression, but the experience seems to be the same before at all Stee's Cartridge Imrulator, the experience of using this product The liver of this product gives the functio...Leggi di più
- Mounting on KLEANHELOThe installation was perfect with 31 Millimeter SizeMounting without Orifice processingJust drop it with Ston under Fork SpringPre-road is added about 15 mm, but as it isWithout a...Leggi di più
- Although I purchased it, in fact it is not attached yet Impression is impossible, but since I replaced Rear suspension with Other Company Product a while ago, I feel a little fear that fun to adjust f...Leggi di più
- Hyper pro's SPG was put in, but since Pad Valve has not been overwhelming, I added PAD Valve. In the processing of Seat pipe, hole of NORMAL is further processed to φ10, shifted by 90-degrees, and...Leggi di più
- To OEM's Z 36 Fork, trial without Orifice processing.Including that Pre-road is applied to Fork itself, I intentionally put it in, but a sense of damping occurred properly.I think that adjustment ...Leggi di più
- It is installed in KYB Φ 36 OEMFork of Z1000 mk 2 series.In theory we tried to introduce with the idea that if the perfect setting can be made with this, it should become structurally superior with re...Leggi di più
- the back whose processing of the Compression hole of a Piston rod was troublesome is unclear, although adjustment of a Pre-road takes with two rotations and is in an opinion -- it is intelligible, if ...Leggi di più
IL PIÙ GRANDE
NEGOZIO ONLINE IN GIAPPONE
BUONI SCONTI ESCLUSIVI,
OFFERTE, AFFARI
RAPIDE & AFFIDABILI
SPEDIZIONI