Made by HURRICANE's Separate Handle used for SRX.
I purchased and installed this product as its Inner Weight,
The effect is insignificant .......
After all the single vibrations can not be accommodated if there is no large weight in the end part too !?
It is necessary examination in the future.
I bought it with expectation for the effect, but it was hardly effective. In Touring etc. I get numbness when using high speed, but it did not go far. I do not feel like I was relieved - - - I think that every product is the same thing.View Detail
Because I am the accident sequelae
If the hands are numb and easy to improve even a little
I bought it for purchase
I think that the impression became somewhat
I think that it was correct purchase.View Detail
Installation itself can be easily done by Sunday mechanic or beginners.
I think that it is difficult to idle when inserting into the Handlebar after a little tightening.
There are about 2 points to be aware of.
(1) Purchase from confirming whether the end of Throttle sleeve is Penetrating.
If the end is not Penetrating, drop the edge (cut) You need to either Penetrating or exchange it for Openle End Type Sleeve.
(2) If it is an OEMHandlebar check to see if the Tap for OEMBar End has been cut off.
In the case of a vehicle with an OEMBar End, I think there is almost a padding. (Especially Kawasaki)
Please check it after purchasing.
Since I attached it to the SR 400, the end of Sleeve dropped by Belt sander. Since the outside Handlebar is attached, there were no other problems to mention other.
Although it is about performance, it is giving up that the vehicle completely eliminates the vibration only in the vehicle.
What I aimed for this time is to shift the rotation speed that causes unpleasant vibration. It seems that the number of rotations where the vibration is strong is slightly different than this Inner Weight because it was the number of revolutions where vibration is increased exactly when you want to run at a certain speed in a highway driving..
If it is about multi-cylinder bibi, would not it be bothersome?.
Because it can be purchased at a relatively low price, when Grip exchange etc etc. It may be good to wear it at the same time.View Detail
My favorite car is BMW R100RS.
Weak vibration on the Handlebar in the entire range of rotation, Large vibration in the constant rotation range, but since we are removing the Cowl and making it a Handle mirror, the Mirror will be blurred when Large oscillates, so the rear can not be seen at all Was.
Result is‥,
"Is there a feeling effect?" By the degree, Large vibration area was still invisible. (I feel like it seems clearly visible in the weak oscillation zone, but since it was originally visible, it makes much sense ...)
As mentioned above, there seems to be some effects, so depending on the type of car and the situation there may be meaning of installation, but may not be excessive expectation.View Detail
I installed it with Bar End. It can contribute to vibration suppression at low speed and acceleration, making long distance easier. Also, because both ends of the Handlebar are heavy, if you tilt the car body it will go so that the Handlebar can be removed.View Detail
IL PIÙ GRANDE
NEGOZIO ONLINE IN GIAPPONE
BUONI SCONTI ESCLUSIVI,
OFFERTE, AFFARI
RAPIDE & AFFIDABILI
SPEDIZIONI