There was no leakage of gasoline, and there was no rust or deterioration of the tank itself, but Rubber packing has become hard, so I replaced it
Parts supply units are not only Single Item for rubber packing, but also The three points were the Nozzle part of Plastic and the Pipe attached to the end of it
Rubber packing alone would have been fine, but Nozzle and Pipe are always Quantity because it's soaked in gasoline:You can replace them at the same time with a set
The old and new comparison of Rubber packing was that the thickness of packing was a little thicker (the Maybe the old one had become harder and thinner due to deterioration) and the wider circumferential width It is
Both differences are differences that work in favor of Gasoline leaks, so I'm glad I updated It is
The price was less expensive than a typical Net shopping experience (About half the price.)
However, the searchability on Webike was not good Also, the part number alone did not include a photo, and we had to match the part number on Webike with a photo of the item on the Net shopping site I had to check the integrity of the product
It's a shame they don't post pictures of it on their website, because I purchased it, and they should be able to post those pictures on their website It is
This is not a question or complaint about Repair Parts that I purchased this time, but I'd like to point out that the inside lid (with the map symbol It is a projection on the periphery of a lighthouse-shaped flat lid (made of the genus Gold)
I think it was a protrusion that was required by the design, but the protrusion is a partial (to the protrusion The protrusions on the inside lid will make a dent in the flat part of the packing (the protrusions will not be visible on the inside of the packing) when you put it on and off If you tighten the lid against (the part that is not recessed against), the Gasoline smell is prolonged That is
The Gasoline smell is short when you match the protrusion of the inside lid to the recess in the Packing
If the outer edge of the lid is not projecting, the packing can be prevented from being partially deformed, and the inner lid can be used to prevent the packing from being deformed I felt like I could get a stable seal
IL PIÙ GRANDE
NEGOZIO ONLINE IN GIAPPONE
BUONI SCONTI ESCLUSIVI,
OFFERTE, AFFARI
RAPIDE & AFFIDABILI
SPEDIZIONI