Mentre la maggior parte dei prodotti sul mercato sono 58,5mm (156cc), abbiamo adottato la fusione da 58mm con un rapporto alesaggio/corsa 1:1 e peso del pistone per dare importanza alla risposta e alla sensazione di alto numero di giri del motore..
L'albero a camme alto ADVANCEPRO tipo X è perfetto per gli alti giri!.
58.La velocità dei pistoni diventa zero al punto morto superiore e inferiore, quindi 1 g di peso è l'equivalente di 1 g di carico sulla manovella. misura.
Questo kit è stato progettato con un'elevata compressione e un'elevata altezza del pistone per aumentare la coppia e la potenza complessive..
Ci sono molti fattori in un motore in rotazione, ma se si forza il motore a ruotare, sarà sempre distorto e rotto..
Una delle equazioni per una rotazione bilanciata è un rapporto alesaggio/corsa il più vicino possibile a 1:1..
Il BWS125 standard ha una corsa di 57,8 mm, quindi i pistoni fusi da 58 mm sono una grande dimensione per questo kit e i pistoni leggeri mettono meno carico sulla manovella, il che rende più facile la rotazione da basso ad alto numero di giri..
While most of the products on the market are 58.5mm (156cc), the bore: stroke ratio is 1: 1, The piston weight is carefully selected, and a cast 58mm piston is used for the engine response and high-rpm feeling.
It is a perfect match with ADVANCEPro's high camshaft Type X for higher RPM.
You may wonder how many grams of weight is reduced between 58.5mm and 58mm, but since the speed of the piston is reduced to zero at the upper and lower dead center, 1g will bounce back to the crank with a considerable load G. Therefore, this kit uses a lightweight cast piston instead of a forged piston, even though the pistons are of the same size. Therefore, this kit uses lightweight cast pistons instead of forged pistons even though they are the same size.
This kit is designed for high compression with high piston height, which contributes to increased torque and power in the entire range.
There are many factors that go into an engine that turns, but if the engine is turned too hard, it will always be distorted and broken.
One of the equations for a balanced turn is to keep the bore x stroke ratio as close to 1.0 as possible: 1.
The standard stroke of the BWS125 is 57.8mm, which is a very good size for the 58mm cast piston of this kit, and the use of this lightweight piston reduces the load on the crank and makes it turn very comfortably from low to high rpm.