- Adatto per::
- KAWASAKI
- KAWASAKI Z1000 (air-cooled) A1/A2
- KAWASAKI Z750 (air-cooled) A4/A5
- KAWASAKI
- KAWASAKI
- ...e altro.
We replaced it when we renewed the Dynamo system. Although there is no visible difference compared to the one that had been used for about 50 years, it is a relief to replace it with a new one.Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...e altro.
After 10,000km, the front clutch started to slip when cold, so I changed it. When I took it off, I found that it had decreased. The clutch is very normal, but the lever is much lighter and I am glad t...Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
By replacing the Fuse1 pcSpec. of NORMAL with this Fuse box, you can get a more stable feeling.I don't think it is necessary to be concerned with the original for the parts related to the invisible th...Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
The Fuse box is more solid than P's multi-system Harness, but it is made to be inserted between the Handlebar Switch, so the wiring under the tank and in the light case is quite bulky. It is also bulk...Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...e altro.
I used it for Engine overhaul in PAMS.Material in the Engine:For Rubber products, you want to use trustworthy products from a reliable Shop.We recommend you to use this product for engine overhaul.Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...e altro.
I am using this Grommet for Oil leak.Two and a half years of use and no leaks so far.This Grommet is an overwhelming performance Grommet compared to the existing Grommet that was on the market.But eve...Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
The Bar End is lower than the Type III, so the wrist is in a more comfortable position.It looks like a YB Handlebar, but the Handlebar Clamp is normal width, so it can be installed without machining t...Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
STD Handlebar is cut a little bit.It's a good handlebar for long touring without looking vulgar because of its height and no aperture.Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
I used it for Overhaul. Next time you open the Engine, it will be easier to remove the Gasket.Leggi di più - Adatto per::
- KAWASAKI
It's very easy to use, the moment you turn on the Blinker switch, it starts with the light on. Also, the light of Blinker became very bright.RelayBody is SEA BASSOEM Parts around 1990's GSXR-1100.Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
It is not a special bearing because it is a bearing sold at PAMS, but it is a quantity of a normal bearing.:SetAlso, in the pictures and product descriptions, the Quantity of Bearing of NSK and NTN:It...Leggi di più - Adatto per::
- KAWASAKI
Hazard is a super~high flasher and the MADE IN USA Relay is here to stay!Because I heard that even if you buy a cheap one of the same type, it will break immediately, I replaced it with the ICRelay ma...Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...e altro.
Aging around the Clutch? It is thrown in together with the clutch plate when it is replaced byIncluding the material, it is said that the parts were produced by the experience of the Z specialty store...Leggi di più - Adatto per::
- SUZUKI GS750
- SUZUKI GS1100
- KAWASAKI Z900 (KZ900)
- KAWASAKI Z750FX
- KAWASAKI Z750
- ...e altro.
In the early days, sp2 did not have a terminal, and the plug cord was stripped and fixed with Bond.It's easy to install now.Because the Plug cap that had been put on before had deteriorated, or perhap...Leggi di più - Adatto per::
- KAWASAKI
Responsiveness compared to OEM Product and OEM ProductRipro's Round Type Quickly, I felt less anxious when changing lanes, SwitchSlide and take a breath and blink As the name implies, it will change t...Leggi di più - Adatto per::
- SUZUKI GS750
- SUZUKI GS1100
- KAWASAKI Z900 (KZ900)
- KAWASAKI Z750FX
- KAWASAKI Z750
- ...e altro.
It's in use on the KZ1000JShop-recommended plug cord, endorsed by Best Match with AS Votani SP2!I didn't put it on myself, but the installation is much betterThe black plug cap is NORMAL and I like th...Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...e altro.
OEM missing push rodThanks to PAMS for selling these partsPush rod operation when disassembling below the waist to resolve the underlying Push Rod Damage I think the best thing to do would be to repla...Leggi di più - Adatto per::
- KAWASAKI Z2 (RS)
- KAWASAKI
The voltage was more stable than Regulator that I used beforeI use a Yoshimuramulti-temp meter to check the voltage while driving, and the voltage is well controlled at about 14.4 V. The voltage does ...Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...e altro.
This is the first part that we have to use RiproParts because there is no OEM parts setupIt's great that it's clearly stated that it's a Viton material with unrivalled strength for gasoline and oil Ma...Leggi di più - Adatto per::
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...e altro.
I am very disappointed and angry.
I have bought the Kit de conversion du système d'embrayage PAMS Modèle : CCVK-WOC, it not suitable for Kawa Z1 discs.
Ok, i buy these discs, springs and so on fr...Leggi di più
IL PIÙ GRANDE
NEGOZIO ONLINE IN GIAPPONE
BUONI SCONTI ESCLUSIVI,
OFFERTE, AFFARI
RAPIDE & AFFIDABILI
SPEDIZIONI